Dell PowerEdge R530 - Initializing the TPM for Bitlocker Users; Initializing the TPM for TXT Users

Figure 88. Installing the TPM
1 rivet slot on the system board 2 plastic rivet
3 TPM 4 TPM connector
Next steps
1 Install the system board.
2 Follow the procedure listed in the After working inside your system section.
Related link
Safety instructions
Before working inside your system
After working inside your system
Initializing the TPM for BitLocker users
Initialize the TPM.
For more information about initializing the TPM, see http://technet.microsoft.com/en-us/library/cc753140.aspx.
The TPM Status changes to Enabled, Activated.
Initializing the TPM for TXT users
1 While booting your system, press F2 to enter System Setup.
2 On the System Setup Main Menu screen, click System BIOS → System Security Settings.
3 From the TPM Security option, select On with Pre-boot Measurements.
4 From the TPM Command option, select Activate.
5 Save the settings.
6 Restart your system.
7 Enter System Setup again.
8 On the System Setup Main Menu screen, click System BIOS → System Security Settings.
9 From the Intel TXT option, select On.
160
Installing and removing system components