Dell PowerEdge R530 - NIC Ports; Serial Connector; VGA Ports; Internal Dual SD Module

Table 18. USB specications
System Front panel Back panel Internal
PowerEdge R530
• One 4-pin, USB 2.0-compliant
port
• One USB management port/
iDRAC Direct
Two USB ports, 1 USB 3.0-
compliant port and 1 USB 2.0–
compliant port
One 9-pin, USB 3.0-compliant port
NIC ports
The PowerEdge R530 system supports four 10/100/1000 Gbps Network Interface Controller (NIC) ports on the back panel.
Serial connector
The serial connector connects a serial device to the system. The PowerEdge R530 system supports one serial connector on the back
panel, which is a 9-pin connector, Data Terminal Equipment (DTE), 16550-compliant.
VGA ports
The Video Graphic Array (VGA) port enables you to connect the system to a VGA display. The PowerEdge R530 system supports two 15-
pin VGA ports on the front and back panels.
Internal Dual SD Module
The PowerEdge R530 system supports two optional ash memory card slots with an internal dual SD module.
NOTE
: One card slot is dedicated for redundancy.
Video specications
The PowerEdge R530 system supports Matrox G200eR2 graphics card with 16 MB capacity.
Table 19. Supported video resolution options
Resolution Refresh rate (Hz) Color depth (bits)
640x480 60,70 8, 16, 32
800x600 60,75, 85 8, 16, 32
1024x768 60,75, 85 8, 16, 32
1152x864 60,75, 85 8, 16, 32
1280x1024 60,75 8, 16, 32
1440x900 60 8, 16, 32
Technical specications 29