Dell PowerEdge R530 - Removing a Hard Drive from a Hard Drive Carrier

2 Keep the Phillips #2 screwdriver ready.
3 Install the 2.5-inch hot swappable hard drive into the 3.5-inch hard drive adapter.
Steps
1 Insert the 3.5-inch hard drive adapter into the 3.5-inch hot swappable hard drive carrier with the connector end of the hard drive
toward the back of the 3.5-inch hot swappable hard drive carrier.
2 Align the screw holes on the 3.5-inch hard drive adapter and the 3.5-inch hard drive with the holes on the 3.5-inch hot swappable hard
drive carrier.
3 Install the screws to secure the 3.5-inch hard drive adapter to the 3.5-inch hot swappable hard drive carrier.
Figure 30. Installing a 3.5-inch hard drive adapter into a hot swappable hard drive carrier
1
3.5-inch hot swappable hard drive carrier 2 screw (5)
3 hard drive adapter
4 2.5-inch hard drive
Next step
Install the 3.5-inch hot swappable hard drive carrier into the system.
Related link
Safety instructions
Removing a hard drive from a hard drive carrier
Prerequisites
1 Keep the Phillips #1 screwdriver ready.
2 Remove the hot swappable hard drive carrier from the system.
Steps
1 Remove the screws from the slide rails on the hard drive carrier.
2 Lift the hard drive out of the hard drive carrier.
88
Installing and removing system components