Dell PowerEdge R530 - Internal USB Memory Key (Optional)

2 Follow the procedure listed in the Before working inside your system section.
Steps
1 Align the fan with the cable end of the fan toward the system board connector .
2 Lower the fan into the fan bracket until it clicks into position.
3 Connect the fan power cable to the corresponding power connector on the system board .
4 Route the cable through the cable holders on the fan bracket.
Figure 36. Installing the cooling fan
1
cooling fans (5) 2 cooling fan release tab
3 cooling fan cable connector 4 cooling fan connector on the system board
Next step
Follow the procedure listed in the After working inside your system section.
Related link
Safety instructions
Before working inside your system
After working inside your system
Internal USB memory key (optional)
An optional USB memory key installed inside your system can be used as a boot device, security key, or mass storage device.
To boot from the USB memory key, congure the USB memory key with a boot image and then specify the USB memory key in the boot
sequence in System Setup.
The internal USB port must be enabled in Internal USB Port option in the Integrated Devices screen of System Setup.
94
Installing and removing system components