6. Slide the expansion card latch into position.
Figure 50. Installing an expansion card
1. expansion card connector 2. expansion card latch
3. expansion card 4. expansion card connector on the system board
7. Follow the procedure listed in the After working inside your system section.
8. Install any device drivers needed for the card as described in the documentation for the card.
Related tasks
Removing expansion card risers
After working inside your system
Removing an expansion card
Installing expansion card risers
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
1. If removed, install the expansion cards into the expansion card riser.
2. Align the expansion card riser with the connector and the riser guide pin on the system board.
3. Lower the expansion card riser into place until the expansion card riser connector is fully seated in the connector.
Installing and removing system components
101
To Next Page
Loading...
