5. SAS cable connector (2) 6. guide pin
7. guide pin slot 8. backplane
Figure 86. Installing the 1.8-inch (x24) hard drive backplane
1.
SD signal cable (3) 2. SD signal cable connector (2)
3. SAS cables (4) 4. SAS cable connector (4)
5. guide pin 6. guide pin slot
7. backplane 8. release tab (2)
1. Install the hard drives in their original locations.
2. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions
Getting help
Using system diagnostics
Related tasks
Before working inside your system
After working inside your system
Removing the hard drive backplane
Control panel assembly
Removing the control panel board–eight hard drive system
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
CAUTION: The display module connector is a ZIF (zero insertion force) connector. Ensure that the locking tab
on the connector is released before removal and insertion. The locking tab must be engaged after insertion.
1. Follow the safety guidelines listed in the Safety instructions section.
Installing and removing system components
137
To Next Page
Loading...
