Dell PowerEdge R630 - Three-Riser Chassis

Related references
Expansion card installation guidelines
Three-riser chassis
NOTE: This is applicable for eight x 2.5-inch, 10 x 2.5-inch, or 24 x 1.8-inch hard drive chassis.
Figure 7. Back panel features (three PCIe expansion cards)
1. System identification button 2. System identification connector
3. iDRAC8 Enterprise port 4. LP PCIe expansion card slot (riser 1)
5. Serial connector 6. LP PCIe expansion card slot (riser 2)
7. Video connector 8. USB port (2)
9. LP PCIe expansion card slot (riser 3) 10. Ethernet connectors (4)
11. Power supply (PSU1) 12. Power supply (PSU2)
Table 6. Back panel features (three PCIe expansion cards)
Item Indicator, Button, or
Connector
Icon Description
1 System identification button The identification buttons on the front and back panels can be
used to locate a particular system within a rack.
10/24 hard drive
system
When one of these buttons is pressed,
the system status indicator on the back
flashes until one of the buttons is
pressed again.
Eight hard drive
system
When one of these buttons is pressed,
the LCD panel on the front and the
system status indicator on the back
flashes until one of the buttons is
pressed again.
Press to toggle the system ID on and off. If the system stops
responding during POST, press and hold the system ID button
for more than five seconds to enter BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup) press and
hold for more than 15 seconds.
2 System identification
connector
Enables you to connect the optional system status indicator
assembly through the optional cable management arm.
3 iDRAC8 Enterprise port Dedicated management port.
NOTE: The port is available for use only if the iDRAC8
Enterprise license is installed on your system.
4 LP PCIe expansion card slot
(riser 1)
Enables you to connect a low profile LP PCIe expansion card.
See the Expansion card installation guidelines section.
18 Dell PowerEdge R630 system overview