System battery specifications
The PowerEdge R630 system supports CR 2032 3.0-V lithium coin cell system battery.
Expansion bus specifications
The PowerEdge R630 system supports PCI express (PCIe) generation 3 expansion cards, which must be installed on the system
board by using expansion card risers. This system supports three types of expansion card risers. The following table provides
detailed information about the expansion card riser specifications:
Table 20. Expansion card riser specifications
Expansion card riser PCIe slots on the
riser
Height Length Link
Riser 1
Slot 1 Low Profile Half Length x16
Slot 2 Low Profile Half Length x8
Riser 2
Slot 1 Low Profile Half Length x8
Slot 1 Low Profile Half Length x16
Riser 3
Slot 2 Full height Three-fourth Length x16
Slot 3 Low Profile Half Length x16
NOTE: When using slot 1 on the riser, ensure that both the processors are installed on the system.
NOTE: Only a three-fourth length card is supported for the PCIe expansion card slot (slot 2) on riser 3 when no mini-PERC
card is installed. Supported length with mini-PERC card installed is half length.
Memory specifications
The PowerEdge R630 system supports DDR4 registered DIMMs (RDIMMs) and load-reduced DIMMs (LRDIMMs) at 1866 MT/s,
2133 MT/s, or 2400 MT/s.
Table 21. Memory specifications
Memory module sockets Memory capacity Minimum RAM Maximum RAM
Twenty-four 288-pins
● 64 GB quad rank
(LRDIMMs)
● 4 GB or 8 GB single rank
(RDIMMs)
● 8 GB, 16 GB or 32 GB dual
rank (RDIMMs)
● 4 GB with single processor
● 8 GB with dual processors
(minimum one memory
module per processor)
● LRDIMM: Up to 768 GB
with single processor
● LRDIMM: Up to 1536 GB
with dual processors
● RDIMM: Up to 384 GB
with single processor
● RDIMM: Up to 786 GB
with dual processors
Drive specifications
Hard drives
The PowerEdge R630 system supports:
● Up to eight 2.5-inch, internal, hot swappable SAS, SATA, or Nearline SAS hard drives
● Up to ten 2.5-inch, internal, hot swappable SAS, SATA, or Nearline SAS hard drives
32
Technical specifications