● Up to twenty four 1.8-inch, internal, hot swappable SAS, SATA, or Nearline SAS hard drives
Optical drive
The PowerEdge R630 system supports one optional SATA DVD-ROM drive or DVD+/-RW drive on 8 hard drive systems only.
Ports and connectors specifications
USB ports
The PowerEdge R630 system supports:
● USB 2.0-compliant ports on the front panel
● USB 3.0-complaint ports on the back panel
● Internal USB 3.0-compliant port
Table 22. USB specifications
System Front panel Back panel Internal
PowerEdge R630
For eight hard drive systems:
● Two 4-pin, USB 2.0-
compliant ports
● vFlash memory card slot
For 24 or 10 hard drive
systems:
● One micro USB 2.0-
compliant port
Two 9-pin, USB 3.0-compliant
ports
One 9-pin, USB 3.0-compliant
NIC ports
The PowerEdge R630 system supports four Network Interface Controller (NIC) ports on the back panel, which is available in
one of the following three NIC configurations:
● Four 10/100/1000 Mbps
● Two 10/100/1000 Mbps and two 100 Mbps/1 Gbps/10 Gbps
● Four 10 Gbps
Serial connector
The serial connector connects a serial device to the system. The PowerEdge R630 system supports one serial connector on the
back panel, which is a 9-pin connector, Data Terminal Equipment (DTE), 16550-compliant.
VGA ports
The Video Graphic Array (VGA) port enables you to connect the system to a VGA display. The PowerEdge R630 system
supports two 15-pin VGA ports on the front and back panels.
Internal Dual SD Module
The PowerEdge R630 system supports two optional flash memory card slots with an internal dual SD module.
NOTE: One card slot is dedicated for redundancy.
Technical specifications 33
To Next Page
Loading...
