2. Follow the procedure listed in the Before working inside your system section.
3. Ensure that all internal cables are connected and placed out of the way, and no tools or extra parts are left inside the
system.
1. Align the slots on the system cover with the tabs on the chassis.
2. Push the system cover latch down.
The system cover slides forward and the slots on the system cover engage with the tabs on the chassis. The system cover
latch locks into place when the system cover is completely engaged with the tabs on the chassis.
3. Rotate the latch release lock clockwise to the locked position.
Figure 21. Installing the system cover
a. latch release lock
b. latch
c. system cover
1. If removed, install the front bezel.
2. Reconnect the peripherals and connect the system to the electrical outlet.
3. Turn on the system, including any attached peripherals.
4. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions
Related tasks
Installing the optional front bezel
Removing the system cover
Inside the system
NOTE: Components that are hot swappable are marked orange and touch points on the components are marked blue.
Installing and removing system components 75
To Next Page
Loading...
