NOTE: To avoid damaging the backplane, ensure to move the control panel cables from the cable routing clips before
removing the backplane.
NOTE: Route the cables properly when you replace it to prevent the cables from being pinched or crimped.
Steps
1. Use the guides on the system to align the slots on the backplane.
2. Insert the backplane into the guides and lower the backplane until the blue release tabs clicks into place.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 87. Installing the drive backplane
3. Route the cables properly through the cable guide and connect the cables to the connector on the system board. Tighten
the captive screw on the cable guiding latch.
NOTE:
The center bracket may have foam (perfect sealing) available. Ensure to replace the foam before routing the
cables.
Next steps
1. Install the drive carrier.
2. If removed, install the air shroud.
3. Install the drive backplane cover.
4. Follow the procedure listed in After working inside your system.
Removing the 14 x EDSFF E3.S drive backplane
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, remove the drives from the system before removing
the backplane.
CAUTION: Note the number of each drive and temporarily label them before you remove the drive so that you
can reinstall them in the same location.
Installing and removing system components 127
To Next Page
Loading...
