Dell PowerEdge R660 - Installing the front mounting front PERC module

Figure 99. Removing the front PERC card from the PERC mounting tray
Next steps
1. Replace the front mounting front PERC module.
Installing the front mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the drive backplane cover.
4. If installed, remove the air shroud.
5. Route the cable properly to prevent the cable from being pinched or crimped. For detailed cable routing instructions, see the
cable routing section.
Steps
1. Align the holes on front PERC card to the guides on the PERC mounting tray.
2. Install the front PERC card on the PERC mounting tray.
Installing and removing system components
137