Figure 72. Configuration 4-1: 10 x 2.5-inch SAS4/SATA RAID (with FPERC11)
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 74. 10 x 2.5-inch SAS4/SATA RAID (with FPERC11)
Order From To
1 SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
2 SL1 (signal connector on system board) CTRL_DST_PA1 (front PERC)
3 CTRL_SRC_SB1 (front PERC) BP_DST_SB1 (backplane signal connector)
Figure 73. Configuration 4-2: 10 x 2.5-inch SAS4/SATA RAID (with FPERC12)
Installing and removing system components
101
To Next Page
Loading...
