Dell PowerEdge R6615 9JNDF - Page 103

Figure 75. Configuration 4-4: 10 x 2.5-inch with 4x Uni G4 (with FPERC12)
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 77. 10 x 2.5-inch with 4x Uni G4 (with FPERC11)
Order From To
1 SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
2 SL1 (signal connector on system board) CTRL_DST_PA1 (front PERC)
3 SL3 (signal connector on system board) CTRL_DST_PB1 (front PERC)
4 CTRL_SRC_SB1 (front PERC) BP_DST_SB1 (backplane signal connector)
5 CTRL_SRC_SA1_PA1 (front PERC) BP_DST_SA1 (backplane signal connector)
6 SL7 (signal connector on system board) BP_DST_PB2 (backplane signal connector)
7 SL8 (signal connector on system board) BP_DST_PA3 (backplane signal connector)
Installing and removing system components 103