Figure 76. Configuration 4-5: 10 x 2.5-inch SAS4/SATA RAID with Rear 2 x 2.5-inch (with FPERC11)
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 78. 10 x 2.5-inch SAS4/SATA RAID (with FPERC11)
Order From To
1 SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
2 SL1 (signal connector on system board) CTRL_DST_PA1 (front PERC)
3 CTRL_SRC_SB1 (front PERC) BP_DST_SB1 (backplane signal connector) &
R_BP_DST_SA1 (rear backplane)
4 MB_SIG_PWR_0 (system board power connector) R_BP_PWR_1 (rear backplane power connector)
104 Installing and removing system components
To Next Page
Loading...
