Figure 88. Removing the PERC battery
3. Using a Phillips #2 screwdriver, loosen the captive screws on the front PERC module.
4. Slide the front PERC module to disengage from the connector on the drive backplane.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 89. Removing the H965 PERC module
5. Using a Phillips #2 screwdriver, loosen the captive screws on the PERC battery holder.
6. Remove the PERC battery tray out of the system.
NOTE: H965 perc module can be replaced without removing the battery tray.
116 Installing and removing system components
To Next Page
Loading...
