Figure 91. Installing the H965 PERC module
4. Install the PERC battery on to the tray.
5. Guide the power cable through the clip and connect it to the PERC power connector.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 92. Installing the PERC battery
6. Place the PERC battery tray between the E3.S backplane.
7. Using a Phillips #2 screwdriver, tighten the captive screws on the PERC battery holder.
NOTE: H965 perc module can be replaced without removing the battery tray.
118 Installing and removing system components
To Next Page
Loading...
