Dell PowerEdge R6615 9JNDF - Page 200

Before you begin the installation or removal process, follow the Safety instructions and Before working inside your system
instructions.
Table 101. BOSS-N1 module kit components
R660 (quantity) Components in kit
NA BOSS cover
1 M3 x 0.05 x 4.5 mm screws
1 BOSS signal cable
1 BOSS power cable
1 BOSS-N1 module
1 or 2 BOSS-N1 card carrier
1 or 2 M.2 SSD
2 M.2 480 GB information label
2 M.2 960 GB information label
1 BOSS card filler
1 Tech sheet
To remove the BOSS blank :
1. Power off the system and remove the system cover.
2. Using a Phillips #1 screwdriver, remove the screw that secures the BOSS-N1 module bay to the chassis.
3. Remove the blank from the BOSS-N1 module bay.
Figure 174. Removing the BOSS-N1 module blank
To install the BOSS blank:
1. Align the blank with the BOSS-N1 module bay and push it into the bay until it clicks into place.
200
Upgrade Kits