Table 3. Features available on the front of 10 x 2.5-inch drive system (continued)
Item Ports, panels, and
slots
Icon Description
3 Right control panel N/A Contains the power button with integrated power LED, 1 x VGA port,
1 x 2.0 USB port, iDRAC Direct (Micro-AB USB) port, and the iDRAC
Direct status LED.
4 VGA N/A Enables you to connect a display device to the system.
5 Information tag N/A The Express Service Tag is a slide-out label panel that contains
system information such as Service Tag, NIC, MAC address, and so
on. If you have opted for the secure default access to iDRAC, the
Information tag will also contain the iDRAC secure default password.
NOTE: For more information about ports, panels, and slots, see the Technical specifications section.
Rear view of the system
Figure 4. Rear view of system
Table 4. Rear view of the system
Item Ports, panels, or slots Icon Description
1 BOSS N/A Insert BOSS blank when BOSS module is not used.
2 Power supply unit (PSU1) PSU1 is the primary PSU of the system.
3 NIC ports N/A The NIC ports that are integrated on the LOM card provide network
connectivity which is connected to the system board.
4 OCP NIC card N/A The OCP NIC card supports OCP 3.0. The NIC ports are integrated
on the OCP card which is connected to the system board.
5 Dedicated iDRAC9 Ethernet
port
Enables you to remotely access iDRAC. For more information,
see the Integrated Dell Remote Access Controller User's Guide at
www.dell.com/poweredgemanuals.
6 VGA port N/A Enables you to connect a display device to the system.
7 Power supply unit (PSU2) PSU2 is the secondary PSU of the system.
8 PCIe expansion card riser 4
(slot 2)
N/A The expansion card riser enables you to connect PCI Express
expansion cards.For more information, see the Expansion card
installation guidelines section.
9 PCIe expansion card riser 1
(slot 1)
N/A The expansion card riser enables you to connect PCI Express
expansion cards.For more information, see the Expansion card
installation guidelines section.
System overview 11
To Next Page
Loading...
