Dell PowerEdge R6615 - Optional BOSS-N1 module

Next steps
1. Install the BOSS_N1 module.
2. Follow the procedure listed in the After working inside your system.
Optional BOSS-N1 module
Removing the BOSS-N1 module blank
Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Steps
1. Using a Phillips #1 screwdriver, remove the screw that secures the BOSS-N1 module bay to the chassis.
2. Remove the blank from the BOSS-N1 module bay.
Figure 109. Removing the BOSS-N1 module blank
Next steps
1. Replace the BOSS-N1 module blank or install BOSS-N1 module.
Installing the BOSS-N1 module blank
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
Steps
Align the blank with the BOSS-N1 module bay and push it into the bay until it clicks into place.
144
Installing and removing system components