Figure 120. Installing the BOSS-N1card carrier
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Next steps
1. Follow the procedure listed in the After working inside your system.
System battery
Replacing the system battery
Prerequisites
NOTE:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same
or equivalent type that is recommended by the manufacturer. Discard used batteries according to the manufacturer's
instructions. See the Safety instructions that came with your system for more information.
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
4. Locate the battery socket. For more information, see the System board jumpers and connectors section.
Steps
1. Use a plastic scribe and Press the release latch until the battery pops out.
NOTE: Ensure that the + side of the battery is facing upwards.
152 Installing and removing system components
To Next Page
Loading...
