2. Follow the procedure listed in Before working inside your system.
3. Remove the heat sink.
Steps
1. Holding the blue tab on the processor tray, slide the tray into the processor socket rail frame until firmly seated.
Figure 93. Placing the processor tray into the rail frame
2. Push the rail frame down until the blue latches lock into place.
Figure 94. Closing the rail frame
3. Secure the force plate to the processor socket base by tightening the screw. When the screw is fully threaded, the socket is
then actuated. The screw is tightened to a torque value of 12.0 ± 1.2 lbf-in.
NOTE: There is one screw of CPU SRM retention frame marked on the force plate.
116 Installing and removing system components
To Next Page
Loading...
