Dell PowerEdge R6625 - Removing the Expansion Card Risers

Table 96. Config8. R2A+R4 E3 (continued)
CARD TYPE SLOT PRIORITY MAXIMUM NUMBER OF CARDS
Mellanox(NIC: 25Gb) 1,2 2
Broadcom(NIC: 25Gb) 1,2 2
Broadcom(HBA: FC64) 1,2 2
Broadcom(HBA: FC32) 1,2 2
Broadcom(HBA: FC32) 1,2 2
Marvell(HBA: FC32) 1,2 2
Marvell(HBA: FC32) 1,2 2
Broadcom(NIC: 10Gb) 1,2 2
Broadcom(NIC: 10Gb) 1,2 2
Integrated slotel(NIC: 10Gb) 1,2 2
Integrated slotel(NIC: 10Gb) 1,2 2
Integrated slotel(NIC: 1Gb) 1,2 2
Broadcom(NIC: 1Gb) 1,2 2
Integrated slotel(NIC: 1Gb) 1,2 2
Broadcom(NIC: 1Gb) 1,2 2
Mellanox(NIC: NDR200) 1,2 2
Integrated slotel(OCP: 25Gb) Integrated slot 1
Integrated slotel(OCP: 25Gb) Integrated slot 1
Broadcom(OCP: 25Gb) Integrated slot 1
Broadcom(OCP: 25Gb) Integrated slot 1
Broadcom(OCP: 25Gb) Integrated slot 1
Broadcom(OCP: 10Gb) Integrated slot 1
Broadcom(OCP: 10Gb) Integrated slot 1
Integrated slotel(OCP: 10Gb) Integrated slot 1
Integrated slotel(OCP: 10Gb) Integrated slot 1
Broadcom(OCP: 10Gb) Integrated slot 1
Broadcom(OCP: 1Gb) Integrated slot 1
Integrated slotel(OCP: 1Gb) Integrated slot 1
Broadcom(OCP: 1Gb) Integrated slot 1
FOXCONN(BOSS) Integrated slot 1
FOXCONN(BOSS) Integrated slot 1
Removing the expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3.
NOTE:
If BOSS N1 module is installed, ensure to disconnect the BOSS N1 power cable and Signal cable before removing
the Riser 1 cage.
138 Installing and removing system components