Figure 173. Sliding rails with optional CMA
Figure 174. Sliding rails with optional SRB
B13 Stab-in/Drop-in sliding rails for 4-post racks
● Supports drop-in or stab-in installation of the chassis to the rails.
● Support for tool-less installation in 19" EIA-310-E compliant square, un-threaded round hole racks including all generations of
the Dell racks. Also supports tool-less installation in threaded round hole 4-post racks.
● Support for tool-less installation in Dell Titan or Titan-D racks
● Support full extension of the system out of the rack to allow serviceability of key internal components.
● Support for optional cable management arm (CMA).
● Support for optional strain relief bar (SRB).
NOTE:
For situations where CMA support is not required, the outer CMA mounting brackets can be uninstalled from
the sliding rails. This reduces the overall length of the rails and eliminates the potential interferences with rear mounted
PDUs or the rear rack door.
Scan the QRL code for the documentation and trouble-shooting information regarding the installation procedures for Drop-in/
Stab-in rail types.
Installation
189
To Next Page
Loading...
