NOTE: The procedure to install expansion card into the riser 1A, riser 2, or riser 1B is identical.
Steps
1. Pull and lift to open the expansion card retention latch lock.
2. If installed, remove the filler bracket.
NOTE: Store the filler bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain
Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the
system and aid in proper cooling and airflow inside the system.
Figure 82. Removing a filler bracket for a riser 1B
Figure 83. Removing a filler bracket for a riser 1A
Installing and removing system components
85
To Next Page
Loading...
