Next steps
1. Replace the BOSS-N1 module or Install the BOSS-N1 card blank.
Installing the BOSS-N1 module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
Steps
1. Connect the BOSS-N1 power and signal cables to the connectors on the BOSS-N1 module.
Figure 122. Connecting the BOSS-N1 power and signal cables to the BOSS-N1 module
2. Align the BOSS-N1 module at an angle with the controller card module slot.
3. Insert the BOSS-N1 module and push the module horizontally towards the rear of the system until firmly seated.
4. Using the Phillips #1 screwdriver, secure the BOSS-N1 module with the M3 x 0.5 x 4.5 mm screw.
5. Connect the BOSS-N1 power and signal cable to the connectors on the system board.
152
Installing and removing system components
To Next Page
Loading...
