Figure 56. Configuration 3: 8 x 2.5-inch SAS_SATA fPERC11
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 68. Configuration 3: 8 x 2.5-inch SAS_SATA fPERC11
Order From To
1. SIG_PWR_1 (system board power connector) BP_PWR_1 (Front backplane
power connector)
2. SL11_CPU2_PB6 (signal connector on system board) CTRL_DST_PA1 (fPERC input
connector)
Figure 57. Configuration 4: 8 x 2.5-inch SAS_SATA fPERC12
Installing and removing system components
93
To Next Page
Loading...
