Figure 121. Installing the liquid cooling heat sink
Next steps
1. If removed, install the air shroud.
2. Follow the procedure listed in the After working inside your system.
Expansion cards and expansion card risers
NOTE:
A system event entry is logged in the iDRAC Lifecycle Controller if an expansion card riser is not supported or
missing. It does not prevent your system from turning on. However, if a F1/F2 pause occurs with an error message,
see Troubleshooting expansion cards section in the Dell PowerEdge Servers Troubleshooting Guide at www.dell.com/
poweredgemanuals.
Installing and removing system components 157
To Next Page
Loading...
