Dell PowerEdge R7625 - Page 119

Figure 86. C3-2: 8 x U.2 G4 RAID (w/ FPERC11 N)
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 84. 8 x U.2 G4 RAID (w/ FPERC11 N)
Order From To
1 SL5_CPU1_PB2 (signal connector on system
board)
CTRL_DST_PA1 (fPERC input
connector)
2 SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power
connector)
3 CTRL_SRC_PB1 (fPERC controller connector) DST_PA2 (backplane signal connector)
and DST_PB2 (backplane signal
connector)
4 CTRL_SRC_PA1 (fPERC controller connector) DST_PA1 (backplane signal connector)
and DST_PB1 (backplane signal
connector)
Installing and removing system components 119