Dell PowerEdge R7625 - Page 120

Figure 87. C3-3: 8 x U.2 G4 RAID (w/ FPERC12)
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 85. 8 x U.2 G4 RAID (w/ FPERC12)
Order From To
1 SL1_CPU2_PA4 (signal connector on system
board)
CTRL_DST_PA1 (fPERC input
connector)
2 SL2_CPU2_PB4 (signal connector on system
board)
CTRL_DST_PB1 (fPERC input
connector)
3 SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power
connector)
4 CTRL_SRC_PB1 (fPERC controller connector) DST_PA2 (backplane signal connector)
and DST_PB2 (backplane signal
connector)
5 CTRL_SRC_PA1 (fPERC controller connector) DST_PA1 (backplane signal connector)
and DST_PB1 (backplane signal
connector)
120 Installing and removing system components