Dell PowerEdge R7625 - Page 123

Figure 90. C5-1: 16 x U.2 G4 SmartFlow
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 88. 16 x U.2 G4 SmartFlow
Order From To
1 IO_RISER4(CPU2) (Riser 4 connector on system
board)
DST_PA2 (backplane signal connector) and
DST_PB2 (backplane signal connector)
2 SL1_CPU2_PA4 (signal connector on system
board)
DST_PA1 (backplane signal connector)
3 SL2_CPU2_PB4 (signal connector on system
board)
DST_PB1 (backplane signal connector)
4 SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
5 SL3_CPU1_PA1 (signal connector on system
board)
DST_PA2 (backplane signal connector)
6 SL4_CPU1_PB1 (signal connector on system
board)
DST_PB2 (backplane signal connector)
7 SIG_PWR_2 (system board power connector) BP_PWR_1 (backplane power connector)
8 IO_RISER1(CPU1) (Riser 1 connector on system
board)
DST_PA6 (backplane signal connector) and
DST_PB6 (backplane signal connector)
Installing and removing system components 123