14 Rack Installation Guide
Installing the Mounting Rails in the Rack
Installing RapidRails Mounting Rails
NOTE: Ensure that the rotating mounting brackets on the slide assemblies are
in the RapidRail configuration. See Figure 1-5.
1
At the front of the rack cabinet, position one of the mounting rails so that
its mounting-bracket flange fits between the marks or tape you placed
(or numbered locations) on the vertical rails in "Marking the Rack"
on page 10 (see Figure 1-5).
The top mounting hook on the front mounting-bracket flange should
enter the top hole between the marks you made on the vertical rails.
Figure 1-5. Installing RapidRails Mounting Rails
1 mounting hooks (4) 2 push buttons (2) 3 mounting rails (2)
front of rack
1
2
3
To Next Page
Loading...
