Rack Installation Guide 21
Routing Cables
1
Open the wire cable basket on the top of the cable-management arm
,
to
enable cables to be routed within the arms (see Figure 1-9).
Figure 1-9. Routing Cables on the Cable-Management Arm
2
If applicable, connect the system status-indicator cable to its connector
on the system back panel.
Route the system status-indicator cable through the cable-management
arm, and press the LED end into the slot on the end of the cable-
management arm until it snaps into place.
3
Attach the I/O cable connectors and power cable connectors to their
respective connectors on the system back panel.
For details on cable connections, see your system’s
Getting Started Guide
or
Hardware Owner’s Manual
.
NOTE: Use the retainer brackets on the back of the power supplies to provide
strain relief for the power cables.
4
Route the cables along the bend in the cable-management arm.
5
Adjust the cable slack as needed at the hinge position and secure
the cables with the tie wraps (see Figure 1-9).
1 tie wraps (2) 2 system status-indicator cable connector
3 cable-management arm 4 wire cable basket
34
2
1
To Next Page
Loading...
