108 Installing System Components
Figure 3-21. Installing and Removing a LOM Daughter Card
3
Remove all expansion cards from expansion-card riser 2. See "Removing an
Expansion Card" on page 92.
4
Pull back slightly on the two blue retention standoff tabs at the front edge
of the card and gently work the edge of LOM card off of the standoffs.
As the card releases from the standoffs, the connector under the LOM card
disengages from the system board.
5
Slide the card back to release the back edge of the card from the two
support standoffs and lift the card out of the system.
1 retention standoff (2) 2 LOM daughter card connector
3 retention standoff holes (2) 4 LOM daughter card
5 support standoff 6 cutout
5
4
1
2
6
3
To Next Page
Loading...
