98 Installing System Components
Figure 3-16. Removing and Installing the Processor Fan Bracket
Replacing the Fan Bracket
1
Lower the fan bracket down onto the bracket base so that the tabs and
hooks under the bracket fit correctly into the bracket base. See Figure 3-16.
2
With the bracket properly engaged, slide the bracket to lock it in place.
3
Replace the fans in the fan bracket. See "Replacing a Cooling Fan" on
page 83.
4
Reinstall the cooling shrouds. See "Cooling Shrouds" on page 94.
5
Reinstall the expansion-card riser 2. See "Replacing Expansion-Card Riser
2" on page 101.
6
Reinstall the expansion cards from riser 2. See "Installing an Expansion
Card" on page 91.
7
If applicable, reinstall the SAS controller daughter card. See "Installing a
SAS Controller Daughter Card" on page 84.
8
Close the system. See "Closing the System" on page 71.
1 release latch 2 fan bracket
2
1
To Next Page
Loading...
