Figure 75. Installing the filler bracket
Next steps
1. Replace the APERC module.
Installing the adapter PERC module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. If required, remove the air shroud.
4. Remove the cooling fan cage assembly.
5. Remove the expansion card riser.
6. Disconnect all the cables from the adapter PERC (APERC) card, observe the cable routing.
NOTE: Refer to cable routing section for more information.
7. If installing a new APERC module, unpack it and prepare the module for installation.
NOTE: For instructions, see the documentation accompanying the card.
NOTE: APERC module must be installed in slot 3 of riser 2.
Steps
1. Pull and lift the expansion card retention latch lock to open.
2. If installed, remove the filler bracket.
NOTE:
Store the filler bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain
Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the
system and aid in proper cooling and airflow inside the system.
114 Installing and removing system components
To Next Page
Loading...
