Dell PowerEdge R860 - Installing the PEM Power Board

Figure 121. Removing the PEM power board
Next steps
1. Replace the PEM power board.
Installing the PEM power board
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the Air shroud.
4. Remove the Cooling fan cage assembly.
5. Remove the PEM.
Steps
1. Align and lower the PEM power board into the system board connector.
2. Press the power board until seated firmly.
3. Insert the PEM power board cover.
156
Installing and removing system components