New SEL Sensor Messages
The following SEL sensor messages have been added to the systems
management software and remote access card software.
E1716 Chipset
The BIOS has determined
that there is a problem
with the chipset, but is
unable to determine its
origin.
See "Getting Help" in your
Hardware Owner’s Manual.
E1717 IERR
CPU is faulty. Applicable
only for BIOS 1.1.9 and
BMC 2.27 and later.
Either the CPU or system
board must be replaced. See
"Getting Help" in your
Hardware Owner’s Manual.
E1914 DRAC5 Conn
2 Cbl
DRAC5 cable is missing,
loose, or faulty.
Reseat the cable. If
problem persists, replace
the cable. See "Getting
Help" in your Hardware
Owner’s Manual.
E2122 Fatal Mem
Reset
System memory failed. See "Troubleshooting
System Memory" in your
Hardware Owner’s Manual.
I1915 Video Off
Local video is disabled. Information only.
I1916 Video Off
in XX
Remote disabling of local
video currently in process.
Information only.
NOTE: For the full name of an abbreviation or acronym used in this table, see "Glossary"
in your Hardware Owner’s Manual.
Table 2. Sensor Message Definitions
Sensor Number Message Definition
0x26 PCIE Non Fatal
error
A non-fatal error occurred. The system
will continue to operate normally.
Table 1. LCD Status Messages (continued)
Code Test Causes Corrective Actions
To Next Page
Loading...
