Dell PowerEdge R940 - Page 7

9. Hold the PEM handle and lower the PEM until it rmly seats in place.
10. Place the heat sinks, processors, and processor brackets for installation on a static-safe work table.
NOTE: Heat sinks, processors, processor brackets, and DIMMs are not part of the kit. They have to
be ordered separately.
11. Flex the outer edges of the bracket around the processor ensuring that the processor is locked into the clips on
the bracket.
NOTE: Ensure that the pin 1 indicator on the bracket is aligned with the pin 1 indicator on the
processor before placing the bracket on the processor.
Figure 5. Installing processor bracket
12. Place the heat sink on the processor and push down until the processor bracket locks onto the heat sink.
7