56 Installing System Components
Figure 3-8. Cabling the Optional Diskette Drive to the Hard Drive
12
Replace the front drive bezel. See "Replacing the Front Drive Bezel" on
page 49.
13
Close the system. See "Closing the System" on page 47.
14
Reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
15
Enter the System Setup program and ensure that the drive’s controller is
enabled. See "Using the System Setup Program" on page 29.
1 system board 2 diskette drive connector
3 diskette drive ribbon cable 4 heat sink shroud tab (2)
5 SATA power convert cable 6 front drive bezel
7 diskette drive ribbon cable 8 cable clip
9 SATA hard drive cables (2)
book.book Page 56 Wednesday, June 24, 2009 8:21 AM
To Next Page
Loading...
