Installing System Components 67
Figure 3-15. Installing a Hard Drive in a Drive Bracket
NOTICE: SAS drives and SATA drives cannot be mixed in the system. The drives
must be either SATA or SAS hard drives.
NOTE: The SAS controller card must be installed in either PCIe SLOT1 or PCIe
SLOT2. See Figure 6-2.
8
Connect the power cable to the hard drive.
9
Connect the data cable to the hard drive:
• For connection to the integrated SATA controller (SATA hard drives
only), connect the SATA data cable to the SATA_A (first drive) and
SATA_B (second drive) connectors on the system board. See
Figure 3-16. See Figure 6-2 for the location of the hard drive
connectors on the system board.
1 hard drive 2 hard drive bracket
book.book Page 67 Wednesday, June 24, 2009 8:21 AM
To Next Page
Loading...
