Dell PowerEdge T110 II - Installing the Cooling Shroud

80 Installing System Components
Figure 3-15. Removing and Installing the Cooling Shroud
Installing the Cooling Shroud
1 Align the holes on the cooling shroud with the alignment guides on the
system fan.
2 Hold the touch points on the cooling shroud and carefully lower the
cooling shroud into the system. Ensure that no cables are under the edges
of the cooling shroud.
3 Replace the expansion-card stabilizer. See "Installing the Expansion-Card
Stabilizer" on page 78.
4 Close the system. See "Closing the System" on page 60.
1 cooling shroud 2 expansion-card stabilizer
3 release tab 4 cooling shroud touch points (2)
1
4
3
2
Coaster_HOM.book Page 80 Monday, November 3, 2014 3:23 PM