Figure 39. Removing and installing a heat sink
1. slots (4) 2. captive screws (4)
3. heat sink 4. processor socket
Next steps
1. If you are removing only a faulty heat sink, install the replacement heat sink, if not, remove the
processor.
2. Follow the procedure listed in After working inside your system.
Related Tasks
Removing the cooling shroud
Installing the heat sink
Installing the processor
Installing the cooling shroud
Removing the processor
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be
performed only by Dell certified service technicians.
1. Ensure that you follow the Safety instructions.
2. Keep the Phillips #2 screwdriver ready.
102
To Next Page
Loading...
