Dell PowerEdge T410 - NIC Indicators; Internal Chassis Views; Power Supply Status; Figure 7. Internal View (Cabled Hard Drive Configuration)

Dell
PowerEdge T410 Technical Guide 16
Power Supply Status Table 3.
LED
Power Supply Status
AC Power is not present
AC Power is present
Fault of any kind is detected
DC Power is applied to the system
↔
Redundant power supply mismatch
(when hot-plugged/swapped)
See the Power Indicator Codes section in the About Your System chapter of the PowerEdge T410
Hardware Owner’s Manual on Support.Dell.com for more information.
4.7 NIC Indicators
See the NIC Indicator Codes section in the About Your System chapter of the PowerEdge T410
Hardware Owner’s Manual on Support.Dell.com for more information.
4.8 Internal Chassis Views
Figure 7 and Figure 8 show the internal views of the PowerEdge T410 server.
Figure 7. Internal View (Cabled Hard Drive Configuration)