120 Installing System Components
Figure 3-15. Removing and Installing the RAID Battery
Installing a RAID Battery
1
Insert the RAID battery into the battery carrier. See Figure 3-15.
2
Align the tabs on the battery carrier with the battery carrier slots
on the chassis.
3
Slide the battery carrier into the battery carrier slots until it locks into
place. See Figure 3-15.
4
Connect the battery cable to the connector on the storage card and replace
the storage controller card. See "Installing an Expansion Card" on page 115.
5
Hold the touch points and lower the expansion card stabilizer.
6
Close the system. See "Closing the System" on page 91.
7
Place the system upright and on its feet on a flat, stable surface.
1 RAID battery 2 battery cable connector
3 battery carrier tabs 4 battery carrier slots (2)
5 battery carrier 6 battery carrier release tab
book.book Page 120 Tuesday, June 9, 2009 4:09 PM
To Next Page
Loading...
