Dell PowerEdge T610 - Page 104

104 Installing System Components
When the front of the card is fully seated, the plastic standoff tabs
snap over the edge of the card.
8 Install the cooling shroud. See "Installing the Cooling Shroud."
9 Install the expansion card stabilizer. See "Installing the Expansion Card
Stabilizer."
10 Close the system. See "Closing the System."
11 Place the system upright and on its feet on a flat, stable surface.
12 Reattach any peripherals, then connect the system to the electrical outlet.
13 Turn on the system and attached peripherals.
Figure 3-13. Installing and Removing the iDRAC6 Enterprise Card
1 iDRAC6 Enterprise card 2 VFlash media slot
3 VFlash SD card 4 RJ-45 Ethernet port (below card)
5 retention standoff posts (2) 6 retention standoff tabs (2)
7 iDRAC6 Enterprise card connector
3
5
1
7
2
6
4
book.book Page 104 Tuesday, September 15, 2009 10:08 AM