Dell PowerEdge T610 - Optical and Tape Drives; Removing an Optical or Tape Drive

Installing System Components 107
Figure 3-14. Removing and Installing a NIC Hardware Key
5 Close the system. See "Closing the System."
6 Place the system upright and on its feet on a flat, stable surface.
7 Reattach any peripherals, then connect the system to the electrical outlet.
8 Turn on the system and attached peripherals.
Optical and Tape Drives
In your system’s two 5.25-inch drive bays, you can install one or two optical
drives, one half-height tape drive, or one full-height tape drive.
Removing an Optical or Tape Drive
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
2 Open the system. See "Opening the System."
3 Remove the expansion card stabilizer. See "Removing the Expansion Card
Stabilizer."
4 Remove the cooling shroud. See "Removing the Cooling Shroud."
1 NIC hardware key 2 ISCSI_KEY connector
1
2
book.book Page 107 Tuesday, September 15, 2009 10:08 AM