Dell PowerEdge T610 - Removing a Hard Drive from a Hard-Drive Carrier; Installing a Hard Drive into a Hard-Drive Carrier

86 Installing System Components
Figure 3-5. Installing a Hot-Swap Hard Drive
3 Install the hot-swap hard drive.
a Press the button on the front of the drive carrier and open the handle.
b Insert the hard-drive carrier into the drive bay until the carrier
contacts the backplane.
c Close the handle to lock the drive in place.
4 Replace the front bezel. See " Installing the Front Bezel."
Removing a Hard Drive From a Hard-Drive Carrier
Remove the screws from the slide rails on the hard-drive carrier and separate
the hard drive from the carrier. See
Figure 3-6 .
Installing a Hard Drive Into a Hard-Drive Carrier
1 Insert the hard drive into the hard-drive carrier with the connector end
of the drive at the back. See
Figure 3-6 .
2 Align the screw holes on the hard drive with the back set of holes on the
hard-drive carrier.
1 release button 2 hard drive carrier handle
2
1
book.book Page 86 Tuesday, September 15, 2009 10:08 AM