Steps
1. Locate the USB port or USB key on the system board.
To locate the USB port, see the System board jumpers and connectors section.
2. If installed, remove the USB key from the USB port.
Figure 51. Removing the internal USB key
1. USB memory key 2. USB port
3. Insert the replacement USB key into the USB port.
Figure 52. Installing the internal USB key
1. USB memory key 2. USB port
Next steps
1. Follow the procedure listed in the After working inside your system section.
2. While booting, press F2 to enter System Setup and verify that the system detects the USB key.
Related Links
Safety instructions
Before working inside your system
After working inside your system
Expansion card holder
122
To Next Page
Loading...
