Dell PowerEdge T630 - Converting the System from Tower Mode to Rack Mode; Preparing for Rack Conversion

2
Converting the system from tower mode
to rack mode
Your system can be converted from the tower mode to the rack mode.
To convert your system from the tower mode to the rack mode, you require the tower to rack
conversion kit, which contains the following items:
• Rack ears (left and right) with three screws each
• VGA module
• Rack slide cover
• Mylar cover
• A pair of rails (optional)
Preparing a system for conversion from tower mode to
rack mode
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Turn off the system, including any attached peripherals, and disconnect the system from the
electrical outlet and peripherals.
4. Lay the system on a flat, stable surface.
5. If installed, remove the system feet or caster wheels. For more information, see removing the system
feet or removing caster wheels.
6. Remove the system cover.
Steps
1. Remove the system top cover. For more information, see the Removing system top cover section.
2. Remove the control-panel assembly. For more information, see the Removing control panel
assembly section.
3. Install the rack slide cover by performing the following steps:
a. Slide the rack slide cover between the system's side cover and the chassis.
b. Slide the rack slide cover toward the back of the system until the tabs on rack slide cover locks
with the tabs extending from the chassis.
28